Description
The Furious Mini RX for Frsky is designed for plam size drones.
Features
Receiver Configuration in the Cleanflight / BetaFlight Configurator
Binding the receiver to the Frsky Taranis
Telemetry Configuration
Just four wires to the FC

Saves a lot of space and weight on your drone

Features
- Mini size : 17x24 mm.
- Light Weight : 2.5g (with antenna).
- Operating Range : 500m.
- S.Bus output without inverted (don’t need inverted on FC).
- 8 channel output.
- Telemetry HUB.
- Input voltage: 4-6V (normal 5V).
- Compatibility: FrSky Taranis, Taranis Plus, & XJT module
Receiver Configuration in the Cleanflight / BetaFlight Configurator
- In the PORTS tab, select the UART that corresponds to the receiver (usually UART3 in F3 flight controllers) and activate Serial RX.
- Save by clicking on the Save and Reboot button.
- In the CONFIGURATION tab, in the Receiver Mode section, select RX_SERIAL.
- In the same tab, in the Serial Receiver Provider section, select SBUS.
- Save by clicking on the Save and Reboot button.
- Go to CLI and type the following commands :
set sbus_inversion = OFF
save - The FC will reboot, applying the change.
- Go to the RECEIVER tab and make sure the receiver acts like it should.
Binding the receiver to the Frsky Taranis
- In the Taranis, go to MODE SETUP (page 2) in the model configuration.
- Go to Mode inside Internal RF and select D8.
- Press and hold the receiver bind button and plug your battery in to turn the receiver on.
- Release the button. A green LED lights up in the receiver.
- Going back to the Taranis and press BIND. The transmitter beeps, indicating it’s in bind mode.
- Wait for the green LED on the receiver to turn off. The binding procedure has finished.
- Exit the BIND mode in the Taranis.
- Unplug the battery to turn off the receiver.
Telemetry Configuration
- In the PORTS tab, select the UART that corresponds to the telemetry (usually UART2 in F3 flight controllers) and select FrSky in Telemetry. Leave the baudrate to AUTO.
- Go to CLI, and type the following commands
set telemetry_inversion = OFF
save - The FC will reboot, applying the change.
- Make sure you’re getting the telemetry values in our Taranis correctly.
Just four wires to the FC

Saves a lot of space and weight on your drone

Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.