 |
Somewhere the INSTRUCTION MANUAL is not enough clear, and have got no pictures how to connect the various cables, i.e. for balance charger of more than one battery with the accessory cable LE-0022 (it's an extra cable, not in the box). FIRST connect the LE-0022 (or the adapter that you find in the GE B6 box -it charges just one battery at one time) to the BALANCE OUTPUT of the GE (you find it on the right side of the charger, at the fan level). Then connect the T female to the T male connector of the MAIN CABLE (output DC cable).
BALANCE CHARGING - IMPORTANT: for the manual do not say much and no pictures show it, I spent quite some time before I realized why the charger kept on displaying the message "CONNECTION BREAK" when I tried to use the balance adapter (LE-0022): you have to full the "line", that is you must NECESSARLY plug in TWO 11.1 V batteries or THREE 7.4V batteries or TWO 7.4V batteries (there are three lines of plugs), because the current goes from + end to - end and if you do not fill the line of the little sockets, the circuit is not closed and the charger warns you of the error. If you want to charge JUST ONE 7.4V or just one 11.1V battery, you must use the adapter you find in the box (this adapter allows you to charge one battery from 7.4V to 22.2V). REMEMBER TO SET THE RIGHT VOLTAGE (22.2V for two 11.1V batteries or three 7.4V batteries, and 14.8V for two 7.4V batteries) prior to start charging. Anyway any error is well displayed and alarmed with a beep.
The GE B6 has also 5 data storages, load program, Lithium Battery quick charging (you'd better prefer low charging, if you can), battery discharging mode , a battery storage mode (if you intend not to use for a long time), the possibility to monitor charging on your PC, a temp sensor…
Rating:  [5 of 5 Stars!] |
|
|
